LASER 100

Pair of safety infrared photocells (safety infrared beam) 

Can be used on any type of device: universal use 12V-24V AC / DC

Output contact NO (normally open) or NC (normally closed).

The photocells are constituted by a receiver(RX) and a transmitter(TX).

Maximum distance between transmitter and receiver: 15m

The photocells are a safety auxiliary ACTIVE device.

A beam of infrared light is transmitted from the transmitter photocell to the receiver photocell.

In case an obstacle causes the infrared beam discontinuation, it determines, during the closing operation, the reversal of the direction of travel of the gate.

It's a valid optional accessory to complete any automation system.

Appropriately positioned ( directly on the pillars or on dedicated columns ) it prevents any contact with any obstacle that passes the driveway during the closing of the gate.

ATTENTION:

All DUCATI gate and garage door openers  already have an integrated  security obstacle detection system. The integrated safety obstacle detection system controls the pressure exercised  by the gate or door in case of impact on an obstacle and  take off pressure within a very short time as  required by the European norms.

The integrated safety system guarantees the safety of persons in full compliance with current European legislation:

EN 13241-1: 2003 + A1

12453: 2000

EN12455: 2000

As the integrated safety system does not prevent  contact with the obstacle, photocells are a non-mandatory safety accessory  that can be added to your automation to avoid contact with any obstacle.

Useful to avoid, for example, scratches to the bodywork of a vehicle crossing the driveway while the gate or door is closing

Attention: Photocells are mandatory obligatory in cases where the gate or the door open on a public area.

photocells can be installed directly on the pillar or columns dedicated.

Optionally you can also install more pairs of photocells on the same plant.

MEASURES: 75mm x 25mm x 30mm